Derris Ventures

The PDM+ is a personal sustainable single gas detector designed to detect Oxygen deficiency and the presence of toxic gas in the ambient environment. The PDM+ is sustainable and has TWA and STEL available, hence its battery and sensor can be replaced. When turned on, PDM+ continuously monitors ambient air for the presence of a specific gas and alerts the user to potentially unsafe exposure with LED, vibrating, and audible alarms if the gas concentration exceeds alarm set points. After use, the instrument can be turned off.

• TWA and STEL
• Lightweighted & Compact
• Stores up to 30 events
• Low cost of ownership
• Sustainable
• IP-67
• Fast bump tests with Docking Station
• Visual, Acoustic and Vibration alarms

• Size	48mm (W) x 85mm (H) x 22mm (D)
  Weight	93g (Toxic) / 104g (O2) (Battery clip included)
  Sensor Technology	Electrochemical Cell
  Temperature	-40°C ~+50°C (Toxic) / -35°C + 50°C  (O2)
  Humidity	5% ~ 95% RH (non-condensing)
  Alarm Type	High Alarm, Low Alarm, TWA Alarm, STEL Alarm, Over Range Alarm, Battery Low Alarm, Bumptest and Calibration due notification
  Alarm Signal	Acoustic: 95 dB @ 30cm Visual: Red flashing LEDs Vibration: Vibration
  Display	LCD Display
  Calibration	2-point calibration, zero and span
  Event Log	30 most recent events
  Battery	Lithium Primary Battery SB-AA02(P) 3.6V, 1.2Ah
  Measurement	Diffusion
  Housing	Polycarbonate and rubber
  Accuracy Deviation	2-3%
  IP-Rating	IP67
  Safety Certifications	ATEX: II 1G Ex ia IICT4 Ga INMETRO: Ex ia IIC T4 Ga IECEX: Ex ia IIC T4 Ga CE: Conformite Europeenne
  Warranty	24 months

 

The Dräger X-am® 2500 was especially developed for use as personal protection. The 1 to 4 gas detector reliably detects combustible gases and vapours, as well as O2, CO, H2S, NO2 and SO2. Reliable and fully mature measuring technology, durable sensors and easy handling ensure a high degree of safety with extremely low operating costs.

 

CASE:High-visibility, impact resistant composite – RFI, EMI and ingressprotection tested and approvedDIMENSIONS:11.2 cm x 6.5 cm x 3.6 cmWEIGHT:243 gWeight with pump: 326 gSENSORS:Combustible Gases – Catalytic DiffusionOxygen and Toxic Gases – ElectrochemicalMEASURING RANGES:Combustibles 0 to 100% LEL in 1% incrementsOxygen 0 to 30% of volume in 0.1% incrementsCarbon Monoxide 0 to 999 ppm in 1 ppm incrementsHydrogen Sulfide 0 to 500 ppm in 1 ppm incrementsThe M40 features LEL over-range protectionPOWER SOURCE:Rechargeable lithium-ion integral batteryRUNTIME:18 hour – instrument (non-alarm)12 hour – instrument with pump (non-alarm)DISPLAY:Large LCD provides simultaneous and continuous readout of up to all fourgases. Large, high-contrast characters, graphic icons and unique amberbacklight provide clear display visibility in low-light conditions.ALARMS:Vibrating, 90 dB audible and ultra-bright LED visual alarms. High/low,STEL, TWA and low battery alarms. Flow alarm indicator when usedwith optional SP40 pump.TEMPERATURE RANGE:-20º to 50ºC (-4º to 122ºF)HUMIDITY RANGE:15 to 95% RH, typical, 0 to 99% RH intermittent (non-condensing)HUMIDITY RANGE:15 to 95% RH, typical, 0 to 99% RH intermittent (non-condensing)CERTIFICATION:IECEx: Ex ia IIC T4 Gb; Ex db ia IIC T4 Gb (with Catalytic Sensor)/ Ex ia IIC T4 Gb; Ex d ia IIC T4 Gb

The Dräger X-am® 2500 was especially developed for use as personal protection. The 1 to 4 gas detector reliably detects combustible gases and vapours, as well as O2, CO, H2S, NO2 and SO2. Reliable and fully mature measuring technology, durable sensors and easy handling ensure a high degree of safety with extremely low operating costs.

 

The robust Dräger Pac® 6500 is your reliable companion under tough conditions. The personal single-gas detection device measures CO, H2S, SO2 or O2 quickly and precisely. Measured data can easily be transmitted into the Dräger Gas Detection Connect system via Bluetooth®. Quick sensor response times and a powerful battery also ensure safety.

 

 

The Dräger Pac® 8500 single-gas detection device is a reliable and precise instrument even under the toughest of conditions. Measured data can easily be transmitted into the Dräger Gas Detection Connect system via Bluetooth®. The device can be equipped with a hydrogen-compensated CO sensor or a Dräger dual sensor. This gives you the option of measuring two gases at once: H2S with CO, H2S with O2 or O2 with CO.

 

The disposable personal single-gas detection device, Dräger Pac® 6000, measures CO, H2S, SO2 or O2 reliably and precisely, even in the toughest conditions. The robust design, quick sensor response times, and a powerful battery ensure maximum safety for up to two years with virtually no maintenance required.

With the robust Dräger Pac® 8000, you'll be well equipped for tough conditions: this non-disposable, personal single-gas detection device is a reliable and precise instrument, which detects hazardous concentrations of 29 different gases, including special gases like NO2, O3 or COCl2. Measured data can easily be transmitted into the Dräger Gas Detection Connect system via Bluetooth®.

Portable Multi Gas Detector (DIFFUSION)MAKE: SENKOMODEL: MGT-PPortable multi gas detector withLEL 0-100% LELO2 0-25% VOLCO 0-500 PPMH2S 0-100 PPMOne Year WarrantyApproval: IECEx / ATEX / PESO Zone 0

• Calibrating the monitor means exposing it to a known concentration of calibration gas or test gas for a specific amount of time. 
• This reading becomes the gas detector's reference point for future readings. 
• Repeat this process each month to ensure accurate readings.
•  Regular calibration is essential in order to maintain reliable performance of most gas detectors.
•  During calibration, thorough testing is also carried out to ensure that the gas detector remains sufficiently sensitive and responsive to the exposure of gas required.
  
  
  

• The PS200 Series combines quality, ruggedness and advanced technology in a user friendly, portable gas monitor. It is compact, lightweight, water resistant, extremely robust, and is certified to multiple international and regional standards. 
• The PS200 can measure any combination of LEL, O2, CO and H2S making it suitable for a wide range of personal monitoring and confined space applications. 
• In addition to extensive datalogging capabilities, the PS200 is available with an optional internal pump and an extensive range of accessories to meet a wide variety of user applications. 
• Importantly, the PS200 has been designed to enable easier user maintenance which includes a fully automatic calibration station to simplify product compliance.

Additional Information:

• Production Capacity: 100
• Packaging Details: 2 years standard warranty against faulty goods or workmanship from date of shipment from Teledyne. Consumable parts are not included. Warranty covers monitor assembly, power supply, and sensors